Lights
DOT required lighting (stop, turn, tail, tag, marker, & clearance)

Front Tack Compartment Area
Tack compartment with feed manger above (saddle rack not standard)
Locking tack door with brush tray, blanket bar and recessed latch
Two bridle hooks in tack compartment

Load Area Equipment
Tubing divider in front stall with solid head and shoulder partition
Two feed doors with chrome circle vents and recessed latches
Solid center gate
Full swing half sliding rear gate
Four interior and four exterior tie rings
Butt chains in front stall with cover

Combo: Standard Features

Available Sizes
Bumper pull, 12' floor length w/2-3500# axles, 15" tires & 5-hole wheels
Bumper pull, 14' floor length w/2-3500# axles, 15" tires & 5-hole wheels
Bumper pull, 16' floor length w/2-5200# axles, 15" tires & 6-hole wheels
Bumper pull, 17' floor length w/2-5200# axles, 15" tires & 6-hole wheels

Dimensions
6'-6" body height
5' or 6' body width
28" tongue length

Undercarriage
Rubber torsion axles with four wheel independent suspension and greasable hubs for easy lubrication
Electric brakes on all wheels
Radial tires on silver modular wheels with chrome center caps
Spare tire rack only

Coupler & Jacks
2" coupler and safety chains with hooks (standard on 5' widths 12'-14' and 6' widths 12')
2-5/16" coupler and safety chains with hooks (standard on 5' widths 16' - 17' and 6' widths 14'-18')
Top-wind screw jack with caster wheel
Emergency breakaway system: switch, cable and battery box complete with battery and charger

Design Features & Hardware
Low profile 6" radius corner galvanneal roof
All steel frame with formed galvanneal panels
4' sides with 1" x 3" tubing above
Rubber mounted optical window in front
Solid side access door on curb side
Treated floor
Greasable exterior hinges
Aluminum tread plate gravel guard
Chrome trim with colored vinyl insert
Pin striping
Tag bracket

Back 40 Supply reserves the right to make any change in paint, design, or construction as necessary for engineering. All visual representation, specification, and dimensions are based on the latest product information available at the time of publication. Some of the equipment shown or described is available at extra cost. At no time will any of the material or information contained in this publication have any justifications for resolving disputes.