Standard Features
Available Sizes
2-horse, 10' floor length w/2-3500# axles, 15" tires & 5-hole wheels
2-horse, 10' floor length w/1-5200# axle, 15" tires & 6-hole wheels
Dimensions
6'-2" body height
6' body width
6' stall length
30" tongue length
Undercarriage
Rubber torsion axles with four wheel independent suspension and greasable hubs for easy lubrication
Electric brakes on all wheels
Radial tires on silver modular wheels with chrome center caps
Coupler & Jacks
2" coupler and safety chains with hooks
Top-wind jack with caster wheel
Emergency breakaway system: switch, cable and battery box complete with battery and charger
Design Features & Hardware
Standard profile 12" radius corner galvanneal roof
All steel frame with formed galvanneal side panels
Rubber mounted optical window in front
Two feed doors with chrome circle vents and recessed latches
Treated floor
Greasable exterior hinges
Chrome trim with colored vinyl insert
Pin striping
Tag bracket
Stall Area Equipment
Tubing divider with a solid head partition
No side padding or breast padding
Floor mats
No side access door
Upper stall sides are open
Double rear doors with hold backs (open area above doors)
Interior and exterior tie rings
Butt chains with cover
Lights
DOT required lighting
Front Tack Compartment Equipment
Tack compartment with feed manger above (saddle rack not standard)
Locking tack door with brush tray, blanket bar and recessed latch
Two bridle hooks in tack compartment
CM Trailers reserves the right to make any change in paint, design, or construction as necessary for engineering. All visual representation, specification, and dimensions are based on the latest product information available at the time of publication. Some of the equipment shown or described is available at extra cost. At no time will any of the material or information contained in this publication have any justifications for resolving disputes. All axle ratings will be listed as per FMVSS 120, Section 5.1 states, the maximum load rating of the tires and rims fitted to an axle shall not be less than the GAWR specified on the certification label.
